How To Fix Power Supply Load Issue Using One Part
In this project we learn how to fix power supply load issue using one part. With
this method, you can easily fix the issue of power drop. Sometimes the power supply doesn’t work properly. it keeps turning on and off.
This usually happens when we connect something heavy like a motor that needs more current than the power supply can give. Because of that, the device doesn’t run smoothly and keeps restarting.
To fix this, we did a little trick. We added a 22k resistor to the input side of the optocoupler inside the power supply. This makes the power supply think the load is not too heavy, so it sends more current to the output.
Basically, we messed with the feedback system a bit. By changing the resistor to 22k, the power supply gives more amps, which helps run heavy loads properly without tripping. It’s like a small hack to increase the output limit.
Post a Comment
Note: Only a member of this blog may post a comment.